Monday, March 31, 2008

Pruning to Correct Tree Structure

Pruning to Correct Tree Structure




Basic Questions to Consider Before Starting
Will the tree be safe after pruning?
Will environmental, insect and disease problems, as well as other predatory conditions, be adjusted to preserve the tree for a valued period of time after pruning?
Will the appearance of the tree be pleasing to the owners?
Be aware of the structural problems of the tree to be saved:Reference the items marked A through F on the sketched tree.
Recognize the degree of rot through broken stumps or rotting leaders left after storm damage, which injures the main trunk. (Note A) This damage has caused cavities, including a basil cavity, and thus further rot has developed in the center of the tree. This tree requires crown reduction to alleviate excessive leverage and stress on the weak main trunk and leaders of the tree.
After the main leaders were broken off approxinmately 25 years ago (Note A), the nourishment generated from the root system went into the development of succulent, high thin growth that is unnatural and unlimited here (Note B). This is due to the lack of abutting trees that would normally compete and restrict the tree's growth, which in most cases would over-shade the tree and cause the death of the tree through natural forest competition. However, here is a tree that we wish to save due to its unique location, historical value, or because it may be the only significant tree in the vicinity.
By inspecting the amount of decay in cavity areas (Note A), one can carefully determine the strength of the remaining trunk and thus the importance of stimulating growth of additional sapwood to strengthen the remaining cylindical sapwood structure that is suporting the tree and, of course, to determine the mount of pruningrequired.
(C,D) Notice the root system is responsible for the growth of the tree more in the direction of the water, with a more vital root system on that side. See the area marked (Note C) as ledge, where the side of the tree is thinner and less vigorous. This dictates that the initial cuts to reduce the crown of the tree will start on the left-hand side over the water and not on the right-hand side over the ledge. The area marked (Note D) demonstrates the weak growth to the right of the area and the excessive, spindly growth to the left.
(E) Weak, rotten stumps that have live growth on them should be left and not removed, except proper cuts should be made to live groth at the broken ends. These cuts will reduce, as much as possible, the drainage of moisture into the main trunk of the tree and thus somewhat limit further rot taking place in the lignified tissue of the inactivexylem.
It is important in lowering the center of gravity of the tree to balance the weakened trunk by encouraging more foliage below. This new foliage will be stimulated in this remaining lower area and branches (Note E). Allowing branches to remain in this lower area, this new foliage will manufacture food and translocate it back to the main trunk. This procedure gives strength to the cylindrical supporting system rather than making cuts close to the trunk and removing some of the structural support. These limbs may not be aesthetically pleasing, but are physicollogically important for the support of the tree. The interior branches need to be lightly pruned to have them form an attractive pattern of new growth, lower down and within the tree's structure.
Once you have appreciated all of these values and considerations, it is now time to move into the tree and start making the six or eight primary cuts throughout the crown (Note F). Start on the side of the tree over the water that needs to be brought back more vigorously, so that area is initially pruned. Those points (Note F) are the areas where the first seven cuts will be made on this tree.
Additional Steps before Pruning Commences
Structural weaknesses, such as V crotches and interior rot, should be observed carefully to help guide the degree and severity of pruning to be done.
Stand back from the tree and view it from all sides. Stand under the tree and view its inner framework. This will allow you to plan the necessary pruning procedures. Presuming that this tree is a large mature deciduous, choose approximately four to ten major cuts that will be made to preserve and establish a central leader and reduce the width of the tree in an attractive manner.
Study the interior of the tree to see small interior growth that can be preserved and stimulated when nourishment is concentrated toward this growth after the above pruning procedures have been carried out. Study the interior growth in order to develop pruning procedures that will result in an attractive, natural, and pleasing pattern of growth.
Explain anticipated additional expense for cabling, bracing, and other treatments to the client.
Long-term costs and other procedures that may need to be done in the future, such as a second pruning (probably eight to ten years after the first pruning), should be estimated.
Establish a complete understanding with the client, preferably in writing, about how the tree will look at completion of pruning specifications that conform to ANSI A300 Pruning Standards.

No comments: